Текст страницы
10) SATA3 0/1/2/3 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The SATA connectors RAID 0,
RAID 1, and RAID 10. Please navigate to the "Configuring a RAID Set" page of GIGABYTE's website for
instructions on configuring a RAID array.
7
1
7
1
SATA3
2
0
3
1
SATA3 0/1/2/3
Pin No.
Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
To enable hot-plugging for the SATA ports, please navigate to the "BIOS Setup" page of GIGABYTE's
website and search for "SATA Configuration" for more information.
11) M2A_CPU/M2B_CPU (M.2 Socket 3 Connectors)
There are two types of M.2 SSDs: M.2 SATA SSDs and M.2 PCIe SSDs. This motherboard only supports
M.2 PCIe SSDs. Please note that an M.2 PCIe SSD cannot be used to create a RAID set with a SATA
hard drive. Please navigate to the "Configuring a RAID Set" page of GIGABYTE's website for instructions
on configuring a RAID array.
110
80
EZ-Latch Plus
M2A_CPU
110
80
M2B_CPU
M2A_CPU
M2B_CPU
•• Installing the M.2 rubber pad:
a. When using a double-sided M.2 SSD, attach the thick rubber pad to the recommended placement
area as shown below.
b. When using a single-sided M.2 SSD, first stick the thin rubber pad to the thick rubber pad, and then
attach them to the recommended placement area as shown below.
Thin Rubber Pad (Gray)
Recommended Pad Placement
Area
Thick Rubber Pad (Black)
80
Avoid contacting any chips or IC components on the motherboard when attaching the rubber pads.
- 23 -