Текст страницы
Error Message
Action
The touchscreen was pressed before the power on initialisation was
completed.
Touchscreen Init.
Failed
Make sure nothing is touching or resting on the touchscreen,
especially when plugging the machine in.
Debris may be stuck between the lower part of the touchscreen and its
frame.
Insert a piece of stiff paper between the lower part of the touchscreen
and its frame and slide it back and forth to push out the debris.
Tray #1 Settings
This message is displayed when the setting to confirm the paper type
and size is enabled.
MP Tray Settings
To not display this confirmation message, change the setting to Off.
For more detailed information, see the Online User's Guide: Change
the Check Paper Size Setting.
A foreign object, such as a paper clip or a piece of ripped paper, is in
the machine.
Unable to Clean
XX
Unable to
Initialize XX
Open the scanner cover and remove any foreign objects and paper
scraps from inside the machine. If the error message continues,
disconnect the machine from the power for several minutes, and then
reconnect it.
Unable to Print
XX
You can try additional paper jam clear operations.
For more detailed information, see the Online User's Guide: Remove
Paper Scraps.
If you cannot print received faxes, transfer them to another fax
machine or to your computer.
For more detailed information, see the Online User's Guide: Transfer
Your Faxes or Fax Journal Report.
Unable to Scan XX
Disconnect the machine from the power for several minutes, and then
reconnect it.
If you cannot print received faxes, transfer them to another fax
machine or to your computer.
For more detailed information, see the Online User's Guide: Transfer
Your Faxes or Fax Journal Report.
A broken device is connected to the USB direct interface.
Unusable Device
B Troubleshooting
Unplug the device from the USB direct interface, then press
to
turn the machine off and then on again.
Disconnect device
from front
connector & turn
machine off &
then on
Unusable Device
A USB device or USB flash drive that is not supported has been
connected to the USB direct interface.
Please disconnect
USB device.
Unplug the device from the USB direct interface. Turn the machine off
and then on again.
23