Текст страницы
EN
DE ES
IT
FR
PT NL RU
FI
SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT
LV
ET
English (Original instructions)
WARNING
Check alignment to ensure a proper seal and
connection.
Always switch off the mains disconnecting switch
when leaving the machine unattended
Flip up the buckles on the base unit and latch to
bucket. Press down on the buckle ends to lock the
bucket to the base unit
BTTERY INSTALLATION (See Figure 4.)
WARNING
Open the door of the battery housing.
Do not fill the bucket with the bucket still fixed on
the base unit.
Align groove in battery pack with raised rib on
pressure washer.
Before adding water to the bucket:
Inspect the filter in the water intake.
Make sure the latch on the pressure washer snaps
in place and that battery pack is secured in pressure
washer before beginning operation.
If the filter is damaged, do not use the machine until
the filter has been replaced.
Close the door.
BATTERY REMOVEL (See Figure 4.)
CONNECTING THE WATER SUPPLY TO PRESSURE
WASHER (See Figure 7.)
Set the switch to the OFF position.
Press the button and take out the battery.
NOTE: If you do not want to use the bucket, you can
use the base unit directly as a pressure washer.
OPERATION
Connect a garden hose to the water inlet.
Attach a garden hose to water supply.
Applications
CAUTION
This pressure washer can be used for the purposes
listed below:
Removing dirt and mould from decks, cement
patios, and walls.
Cleaning cars, boats, motorcycles, outdoor furniture
and barbeques.
CONNECTING HIGH PRESSURE HOSE (See Figure
5.)
Fiting
Push the connector (12) of the high pressure hose
into the mount (13) on the trigger handle until it
engages.
Removing
Actuate the spring button (14) and pull the high
pressure hose out of the mount.
When connecting the appliance to the water sup
ply mains (not public drinking water supply mains),
please observe the local regulations of local boards
or local water supplier.
To ensure that there is no feedback of contaminant
into the water supply, the appliance must not be con
nected directly to the public drinking water supply
mains.
If the appliance is connected to potable water mains,
backflow prevention devices should be incorporated
in or fixed to the water supply system. The instal
lation should be accepted by local boards or water
supplier and should be conducted by professional
technical personnel. The backflow prevention de
vices should be appropriate to fluid categories and
comply with the requirement to avoid back siphon
age according to EN 60335-2-79:2009.
WARNING
USING THE GUN (See Figure 8.)
The washer must be used on a secure and stable
surface in a standing, upright position.
For greater control and safety, keep both hands on the
gun at all times.
ADDING WATER TO THE BUCKET (See Figure 6.)
Squeeze the trigger (15) to operate the pressure
washer.
Release the trigger to stop the flow of water through
the nozzle.
The water supply must come from a water main.
NEVER use hot water or water from ponds, lakes, etc.
For ease of use, a self-coiling hose (not provided) is
recommended.
3