Текст страницы
EN
DE ES
IT
FR
PT NL RU
FI
SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT
LV
ET
English (Original instructions)
Add the water into the bucket.
To engage the lock-out:
Press the lock-out button (16) to the ON position.
Install the bucket and lock it out.
Install the battery pack.
To disengage the lock-out:
Set the switch to the ON position to start the motor.
Press the lock-out button to the OFF position.
Turn the garden hose on then squeeze the high
pressure trigger.
USING THE NOZZLES (See Figure 9.)
MAINTENANCE
CAUTION
WARNING
NEVER change nozzles without engaging the
lock out on the gun and NEVER point the lance
at your face or at others.
To connect a nozzle to the lance:
When servicing, use only identical replacement
parts. Use of any other parts may create a hazard or
cause product damage.
Turn off the pressure washer. Pull trigger to release
water pressure.
WARNING
Engage the lock out on the gun by pulling down on
the lock out until it clicks into the slot.
Press the button on the lance and insert the nozzle,
aligning the pin on the nozzle with the hole.
Rotate the nozzle to adjust the spray shape.
Before inspecting, cleaning, or servicing the ma
chine, shut off motor, wait for all moving parts to stop,
and remove the battery pack. Failure to follow these
instructions can result in serious personal injury or
property damage.
ADDING
DETERGENT
TO
THE
PRESSURE
WASHER (See Figure 10-11.)
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
Use only detergents designed for pressure washers;
household detergents, acids, alkalines, bleaches, sol
vents, flammable material, or industrial grade solutions
can damage the pump. Many detergents may require
mixing prior to use.
WARNING
Prepare cleaning solution as instructed on the solution
bottle.
NOTE: Use a funnel, if needed, to prevent accidental
spilling of the detergent outside the tank. If any
detergent is spilled during the filling process, make sure
the unit is cleaned and dried before proceeding.
To apply soap:
Pour detergent in the detergent tank.
Do not at any time let brake fluids, petrol, petro
leum based products, penetrating oils, etc., come in
contact with plastic parts. Chemicals can damage,
weaken or destroy plastic which may result in seri
ous personal injury. Only the parts shown on the
parts list are intended to be repaired or replaced by
the customer. All other parts should be replaced at
an authorized service centre.
Install the soap tank to the trigger gun.
NOZZLE MAINTENANCE (See Figure 13.)
Start the pressure washer and spray the detergent
on a dry surface using long, even, overlapping
strokes. To prevent streaking, do not allow
detergent to dry on the surface.
Excessive pump pressure (a pulsing action felt while
squeezing the trigger) may be the result of a clogged
or dirty nozzle.
Unplug the pressure washer.
STARTING AND STOPPING THE PRESSURE WASH
ER (See Figure 12.)
Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
Remove the nozzle from the lance.
CAUTION
NOTE: Never point the spray lance at your face.
Using a straightened paper clip or nozzle cleaning
Do not run the pump without the water in the bucket
connected and turned on.
4