Текст страницы
EN
template sticker should be parallel to
and about 107 cm from the ground.
2. Use a power drill with an 8 mm drill bit
Note: Once the vacuum is fully charged, the
indicator will turn off after 5 minutes, and
the vacuum will enter the energy-saving
mode.
Fig. D-2
to drill a hole into each marker on the
mounting template sticker, then insert a
wall plug into each hole.
3. Align the holes on the mount with the
How to Use
holes on the wall. Fasten it to the wall
with the included screws.
Battery Status Display
Fig. C-2
Display Screen
Note:
• The wall mount is an optional accessory.
You can install it based on your needs.
The number on the display screen represents
the current battery level in a percentage
during charging. When the number becomes
100, the battery is fully charged.
Working Methods
• The wall mount should be installed on a
cool, dry surface with an electrical outlet
nearby. Prior to installing, ensure that
there are no electrical wires or pipes in the
space directly behind installment position.
Select from two working methods for the
vacuum, based on your needs.
Method 1: Discontinuous Cleaning Mode
Charging
Press and hold the on/off switch to power it
on, and release it to stop immediately.
Fully charge the vacuum before using it for
the first time.
Fig. E-1
Note:
Method 2: Continuous Cleaning Mode
(Trigger switch lock)
• A full charge will take approximately 4
hours.
Click the trigger switch lock to switch
to Continuous Cleaning Mode when the
vacuum is running. Then release the on/off
switch to make the vacuum in Continuous
Cleaning Mode.
• Using Turbo mode for a prolonged
period will cause the battery to heat up,
which increases charging time. Allow
the vacuum to cool down for 30 minutes
before charging it.
Use the trigger switch lock to free your
fingers and avoid finger fatigue caused by
holding the switch.
Charging Methods
Fig. E-2
Charging the vacuum with the charger
Note:
Fig. D-1
LED Battery Status Indicator
• In this mode, the lock indicator will
illuminate steadily.
Low battery
• Click the trigger switch lock again to quit
the Continuous Cleaning Mode.
Half battery
Nearly full
Fully charged
Using Different Accessories
Smart Multi-Surface Brush
Off
Blinking
On
4