Текст страницы
Fig. F-4
EN Care & Maintenance
Tips:
To reduce the risk of electric shock, do
not rinse the dust cup with water.
1. Always use genuine parts to keep your
warranty from being void.
5. Rinse the cyclone assembly and pre-filter
until they are clean. After washing, air dry
for at least 24 hours .
2. If the filter or nozzle becomes clogged,
Fig. F-5
Note:
the vacuum will stop working shortly
after being turned on. Clear the tube to
restore functionality.
• It is recommended to clean the dust cup
once every month.
3. If the vacuum is not used for an extended
• It is recommended to clean the pre-filter at
least once every 3 months and the cyclone
system at least once every 6 months.
period, fully charge it, unplug its charger,
and store it in a cool, low-humidity
environment away from direct sunlight.
To avoid over-discharging the battery,
recharge the vacuum at least once every
three months.
Installing the Dust Cup, Pre-
Filter, and Cyclone Assembly
Cleaning the Vacuum
Wipe the vacuum with a soft dry cloth.
1. Insert the cyclone assembly vertically
into the dust cup, and make sure that the
handle of the cyclone assembly line up with
the slot on the left side of the dust cup. Turn
the handle clockwise until it locks, then flip
the handle down.
Cleaning the Dust Cup, Pre-
Filter, and Cyclone Assembly
2. Place the pre-filter with its front side
facing up into the cyclone assembly.
Fig. F-6
3. Slightly tilt the dust cup so the slot aligns
with the clip on the vacuum. Then gently
push the dust cup until it clicks into place.
The vacuum's cleaning ability will be
reduced if the dust cup is filled to the "MAX"
mark. To regain performance, empty
the dust cup in a timely manner. Before
emptying the dust cup, make sure the
vacuum is disconnected from the power,
and do not press its power button.
Fig. F-7
1. Press the dust cup bottom cover release
button, then empty the contents.
Cleaning the Filter
Fig. F-1
It is recommended to clean the filter once
every 4 to 6 months.
Fig. F-8
2. Push the dust cup release switch in the
direction indicated by the arrow, then gently
remove the dust cup from the vacuum.
Fig. F-2
1. Remove the dust cup as shown in the
figure.
2. Remove the filter from the vacuum by
pulling it down in the direction shown in the
figure.
3. Remove the pre-filter first, then lift the
handle of the cyclone assembly and turn it
counterclockwise until it stops, then pull to
lift out the cyclone assembly.
Fig. F-9
Fig. F-3
4. Wipe the dust cup with a soft wet cloth.
Pay attention to wringing out the cloth
before using.
3. Clean the filter with clean water. Make
sure you rotate the filter 360° to thoroughly
and remove all dust caught in the filter.
Lightly tap the filter several times to remove
6