Текст страницы
and thoroughly dry it before re-installing.
EN
any excess dirt.
Fig. F-10
Fig. F-18
4. Allow the filter to air dry for 24 hours.
Note：
Fig. F-11
Note：
• Before storing the mop head for an
extended period, empty the water tank and
turn the outflow control switch to OFF.
• Only use clean water to wash the filter. Do
not use detergent.
• Before cleaning, make sure that the
vacuum is powered off.
• Do not attempt to clean the filter with a
brush or finger.
Cleaning the Motorized Mini-
Brush
• It is recommended to clean the filter once
every 4 to 6 months.
1. Use a coin as illustrated to rotate the lock
counterclockwise until you hear a click.
Installing the filter
Fig. F-19
1. Insert the filter into the vacuum and
gently press down, as illustrated.
2. After unlocking the motorized mini-
brush, remove the brush roller, then rinse
and clean it.
2. Reinstall the dust cup.
Fig. F-20
Fig. F-12
2. Reinstall the dust cup.
Fig. F-13
3. Stand the brush roller upright in a well-
ventilated area for at least 24 hours until it is
fully dry.
Fig. F-21
4. Once the brush roller is dry, reinstall it by
following the disassembly steps in reverse.
Cleaning the Smart Multi-
Surface Brush
Fig. F-22
1. Turn the lock counterclockwise until it
stops, then remove the roller from the roller
brush.
Battery Pack
Fig. F-14
2. Use scissors to cut off the hairs and fibers
that get stuck on the brush roller. Wipe the
dust from the notch and transparent cover
with a dry cloth or paper towel. Thoroughly
dry before use.
The vacuum contains a removable
rechargeable lithium-ion battery pack which
has a limited number of recharge cycles.
After extended use, the battery pack may
no longer hold a charge. If this happens, it
means the battery pack has reached the end
of its life cycle and needs to be replaced.
Fig. F-15
3. When it is dirty, rinse the brush roller
with clean water until it is clean.
1. Press down the battery pack release
button and slide the battery pack to the
right, as illustrated, to remove it.
Fig. F-16
2. Install the new battery pack.
Fig. F-23
4. Stand the brush roller upright for at least
24 hours until it is fully dry.
Fig. F-17
Cleaning the Spin Mop Head
Remove the mop pad after the mop head is
flipped. Rinse the mop pad until it is clean,
7