Текст страницы
C1 Filling the Clean Tank
B3 Storage Stand
B1-2—Positioning the charging dock
C1-1—Grip the clean tank handle, press the
release button, and gently pull the
clean tank upwards at a slight angle.
B1-2-1—Place the charging dock upside
down, connect the power cord to
the socket of the charging dock,
and loop the cord inside the cord
storage slot as needed.
B3-1—Put the storage stand on the floor,
and attach the charging dock to the
storage stand with either side of it
aligned with the back of the storage
stand.
C1-2—Open the cap of the clean tank refill
port, add tap water, and then close
the cap.
The power cord can exit from either the right or
left cord storage slot opening.
Note:
B3-2—Install the baton holder onto the
storage stand. Push it until it clicks
into place.
B1-2-2—Place the charging dock on a flat,
hard floor and plug it in.
B1-2-3—Maintenance Brush
Notes:
Notes:
C1-3—Place the clean tank back to the
cleaner head. Push it down gently
until it clicks into place.
B3-3—To remove the baton holder, press
the release button on the back and
pull the holder upwards.
B3-4—Store all parts as shown in the diagram.
Note:
• Do not place the charging dock in humid locations or
near any heat sources, such as bathrooms, kitchens,
and radiators.
• The maintenance brush can be placed in the groove at
the back of the charging dock.
Before placing the handheld vacuum cleaner to
the storage stand, remove the detachable suction unit
to prevent it from falling down.
• To avoid deforming the clean tank, only use cold water.
• To prevent corrosion or damage, do not use
any disinfectant and only use cleaning solutions
recommended by Roborock.
• To enhance cleaning performance, we recommend
adding a quarter of a bottle cap of the suggested
cleaning solution to the filled clean tank.
B2 Handheld Vacuum Cleaner
C2 Locking and Unlocking
C
B2-1—Installing the detachable suction unit
Instructions for
Using the Wet and
Dry Vacuum Cleaner
Lightly step on the cleaner head and hold the
handle. Push it to lock the vacuum cleaner,
and pull it to unlock the vacuum cleaner.
B2-1-1—Press the detachable suction unit
release button, and tilt the suction
unit backward to remove it.
Language Selection
C2-1—Locked
C2-2—Unlocked
C3 Starting the Vacuum Cleaner
B2-1-2—Insert the detachable suction unit
into the handheld vacuum cleaner
and tilt it downwards at a slight
angle until it clicks into place.
B2-2—Installing cleaning heads
Tilt the handle backward to unlock the
vacuum cleaner, and press the
button to
start it.
Press and hold the
and
buttons for 3
seconds to start language selection, then
press the
button to change language.
To confirm your selection, stay upon your
preferred language for 10 seconds or press
the
button.
007