Текст страницы
D1-3—2-in-1 cleaning head (crevice tool)
Routine Maintenance
E
It is suitable for cleaning dust in
narrow spaces such as door/window/
wall corners, and stairs.
button for 5 seconds while charging until
you hear the voice message: "Charge &
Sleep mode enabled" or "Charge & Sleep
mode disabled."
To maintain optimal performance of the
product, refer to the following table for
routine maintenance.
Notes:
D1-4—2-in-1 cleaning head (duster crevice tool)
It is suitable for cleaning dust on
sofas or tabletops.
Part
Maintenance
Frequency
Replacement
Frequency
Roller
As needed
3 months
Filter (dirty
tank)
As needed
As needed
To switch between the crevice tool and
duster crevice tool:
Press the button on the duster brush to
slide it all the way forward/backward.
Filter (dustbin) As needed
N/A
Notes:
• Charge & Sleep mode enabled: After the machine
has been charging for 5 minutes without operation,
the LED display will turn off. After the machine is fully
charged, it will not automatically shut down. To start
self-cleaning and drying, press the
button. If the
machine is removed from the charging dock, it will
remain active, waiting for orders.
• Charge & Sleep mode disabled: Five minutes after
the machine is fully charged, it will automatically shut
down. To start self-cleaning and drying, ensure the
machine is on the charging dock, press the
button
to turn it on, and then press the
button. If the
machine is removed from the charging dock, it will not
remain active and wait for orders.
Cleaner head
and dirty water
pathway
As needed
N/A
Dirty tank
As needed
N/A
Charging dock As needed
N/A
D
Charging
contacts
As needed
N/A
Instructions for
Using the Handheld
Vacuum Cleaner
Dustbin
As needed
N/A
D1 Cleaning Heads
D1-1—Motorized mini-brush
Multi-surface
brush
1 month
N/A
Motorized
mini-brush
1 month
N/A
It is suitable for cleaning dust and
mites on textile products such as
beds, curtains, etc.
Notes:
D1-2—Multi-surface brush
It is suitable for cleaning tiles, floors,
and low-pile carpets with fibers
shorter than 2.5 cm (0.98 in).
• Do not use these cleaning heads to vacuum water.
• Do not touch the rotating part of cleaning heads.
• To prevent scratching the fabric surface, do not use the
motorized mini-brush on leather, leathaire, or silk materials.
• When using the multi-surface brush or motorized
mini-brush, the surfaces of some fabrics may
become fuzzy or exhibit resistance. In this case, it is
recommended to use the 2-in-1 cleaning head.
• Before vacuuming polished surfaces (shiny wooden
flooring or glazed tiles), check if there are objects in
the multi-surface brush (especially the cleaning head)
to avoid scratching the floor.
• Before using the vacuum cleaner, make sure that the
dustbin, multi-cyclone assembly, sponge filter, and
rear filter are properly installed.
• Do not block the exhaust port when vacuuming.
• For fine dust like flour and construction dust, the vacuum
cleaner can be used only if the amount of dust is small.
• Do not use the vacuum cleaner to suck up sharp
objects, small toys, pins, paper clips, etc. These objects
can damage the vacuum cleaner and the floor.
• Pay attention to personal safety when cleaning
dangerous areas such as stairs and windows.
• Do not place the product on high places such as desks
and chairs or lean the product against other objects to
avoid damage caused by it falling or tipping over.
• The movement of the multi-surface brush may result in
an unevenly polished floor. To remedy this, the floor can
be wiped with a damp cloth and polished with floor wax.
• The product must be powered off or stopped running,
and the charging dock unplugged before you clean or
maintain them.
• The frequency of replacement may vary with the actual
situation. If abnormal wear occurs, replace the parts
immediately.
• The filter and roller fibers have been treated with silver
ion antimicrobial agent to resist bacterial odors.
009