Текст страницы
Symbol
Meaning
Unlocked.
Prohibited.
Double Insulation / protection
class.
Fixing wing nut of the body inclination angle scale
Base plate
Fastening screw for parallel guide
Cutting mark at 45° body inclination angle
Cutting mark at 0° body inclination angle
Sliding guard cover lever
Sliding guard cover
Ventilation slots
Auxiliary handle
Lock-off button
Guide
Fixing lever
Wrench
Parallel guide
Internal flange
Spindle
Vacuum cleaner adapter
Screws
Screws
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
* Optional extra
A sign certifying that
theproduct complies with
essential requirements
of the EU directives and
harmonized EU standards.
Not all of the accessories illustrated or described
are included as standard delivery.
Attention. lmportant.
Installation and regulation of
power tool elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Useful information.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
Wear protective gloves.
Mounting / dismounting / setting-up of
some elements is the same for all power
tool models, in this case specific models
are not indicated in the illustration.
During operation, remove the
accumulated dust.
Mounting / dismounting parallel guide (see fig. 1)
Fig. 1 shows parallel guide 22 mounting / dismounting
operations.
Do not dispose of the power
tool in a domestic waste
container.
Replacement of the saw blade (see fig. 2-3)
After prolonged operation, the saw blade
can become very hot, remove it using
gloves. This will also reduce the risk of
injury by the cutting edge.
DWT Power tool designation
The circular saw is designed for cutting wooden piece-
parts. The power tool enables vertical and inclined cuts
as well as cutting depth adjustment.
Using special saw blades enables you to cut plastic
blanks.
Power tool components
• Mount power tool on the side end of the motor as
shown in fig. 2.1.
• Press down spindle lock 7 and rotate saw blade 3
manually in order to lock it in a fixed position. While
pressing down spindle lock 7, unscrew bolt 4 with the
help of wrench 21.
• Use lever 14 to turn sliding guard cover 15 clockwise
against the stop.
• Remove from spindle 24: external flange 5, saw
blade 3, internal flange 23.
• Clean all fixing elements with a soft brush and mount
on the spindle 24: internal flange 23, saw blade 3, ex
ternal flange 5, screw in bolt 4 manually.
Dust removing hole
Guard cover
Saw blade
Saw blade fixing bolt
External flange
On / off switch
Spindle lock
Body tilt angle scale
1
2
3
4
5
6
7
8
Attention! observe the following rules during in
stallation:
• follow the mounting sequence (see fig. 3);
English
14