Текст страницы
for this purpose, the power tool will fail and your war
ranty will be cancelled.
• The saw blades can get very hot during operation - do
not touch them until they have cooled down.
Symbols used in the manual
Following symbols are used in the operation manual,
please remember their meanings. Correct interpreta
tion of the symbols will allow correct and safe use of
the power tool.
Symbol
Meaning
ing, you shall not fetch the machined parts with hands.
• Be sure to clench the power tool tightly with hands. Do
not put your hand or fingers behind the circular saw. If
rebound occurs, the circular saw is likely to jump back
into your hands thus resulting in severe personal injury
(faulty operation is indicated in figure 15.1).
• When cutting is carried out, wider base portion of cir
cular saw shall be placed on stably supported part of
the workpiece rather than on the part to be cut down.
(proper operation is indicated in figure 15.2; fault oper
ation is indicated in figure 15.3) If the workpiece is very
short or small, it should be clamped. Do not make an
attempt to support short workpiece with hands.
• Circular saw shall not be used upside down for saw
ing operation because it is very dangerous and may
even cause severe accident (as shown in figure 16).
Before commencing operation
Circular saw
Ser.No.:
Serial number s ticker:
HKSP... - model;
XX - date of manufacture;
XXXXXXX - serial number.
• Use the power tool only for cutting material recom
mended by the manufacturer.
• The saw blade arrow must always point in the same
direction as the guard cover arrow.
• During operation never fix (bind, wedge, etc.) the slid
ing guard cover open.
• Avoid blocking of the sliding guard cover or its clog
ging with sawdust If this is the case switch off the
power tool, fix the malfunction and only then continue
operation.
Read all safety regulations
and instructions.
During operation
Wear safety goggles.
Wear ear protectors.
Wear a dus t mask
Disconnect the power tool
from the mains before instal
lation or adjustment.
Movement direction.
• Never start cutting until the saw blade reaches its full
speed.
• Always process only one blank - this is the only way
to fix it properly.
• While processing long blanks use the clam ping de
vices and be sure to provide a support under the long
end of the blank. Never make a third person hold the
working blank.
• Never remove sawdust or blank waste-ends while the
power tool motor is running.
• If during operation the saw blade gets stuck in the
blank or is blocked by the waste-ends, immediately
switch off the power tool and only then eliminate the
cause of the saw blade failure.
• Never treat workpieces containing asbestos.
• Do not use the power tool to cut firewood.
• Avoid stopping the power tool motor when under load.
• Avoid overheating your power tool, when using it for
a long time.
• Never cover the cuttings outlet with fingers.
• Never operate the power tool over your head level.
After finishing operation
Rotation direction.
Locked.
• The power tool can be removed from the workplace
only after the saw blade has been switched off and
stopped completely.
• Never try to slow down the inertial rotation of the saw
blade with the spindle lock or by applying effort to the
saw blade lateral surface. If you use the spindle lock
English
13