Текст страницы
Protective device against overheateng
This vacuum cleaner is equipped with a special thermostat, which disconnects the vacuum
cleaner from the power supply when the motor is overloaded. If the vacuum cleaner suddenly
turns off, turn it off by pressing on the switch on/off button and unplug the power cord.
- Make sure that there is power in the outlet. To do this, in order to avoid electric shock, consult
a qualified electrician;
- Check and eliminate possible causes of overheating such as full dust bag/container, tube,
hose or filter clogging, etc;
- After eliminating the found causes, wait about 40 minutes, then reconnect the vacuum cleaner
to the power supply and turn it on.
If the vacuum cleaner does not run, contact an authorized Artel service center.
Assembling the vacuum cleaner and installing accessories
WARNING: Risk of injury or damage to the vacuum cleaner! Install brush and other
accessories only when the vacuum cleaner is disconnected from the power source.
Otherwise, the vacuum cleaner can start sucking hair, clothing, objects, etc.
CAUTION: Before assembling, make sure that the nozzle to be installed is suitable for the
surface to be cleaned. Also pay attention the recommendations of flooring manufacturer.
Note: To avoid detaching some parts such as a brush or hose, make sure that they are
securely fixed in the desired position.
ENGLISH
- To connect the hose, firmly insert it into the cleaner's body (should click) (Figure 1).
- To disconnect the hose, press the release buttons and pull the hose connector out (Figure 2);
VCC0220
VCB0316
VCB/C0120
Figure 1
VCC0220
VCB/C0120
Figure 2
45