Текст страницы
EN
system and pre-filter at least once every
3 to 4 months.
Care & Maintenance
Tips:
Cleaning the Filter
• Always use genuine parts to keep your
warranty from being void.
1. Remove the dust cup as shown in the
figure.
Fig. F-5
• If the filter or nozzle becomes clogged,
the vacuum will stop working shortly
after being turned on. Clear the tube to
restore functionality.
2. Remove the filter from the vacuum by
pulling it down in the direction shown in
the figure.
Fig. F-6
• Before cleaning the dust cup, please
confirm that the plug is disconnected
and keep the vacuum's power button in
the off position.
3. Rinse the filter with rotating it 360° .
Lightly tap the filter several times to
remove any debris caught in it.
Fig. F-7
4. Allow the filter to air dry for 24 hours.
Fig. F-8
Note:
• If the vacuum is not used for an
extended period, fully charge it, unplug
the power cord, remove the battery,
and store it in a cool, low-humidity
environment away from direct sunlight.
To avoid over-discharging the battery,
recharge the battery at least once every
three months.
• Only use clean water to wash the filter.
• Do not use detergent.
Cleaning the Vacuum
• Do not attempt to clean the filter with a
brush or finger.
Wipe the vacuum with a soft dry cloth.
• It is recommended to clean the filter once
every 4 to 6 months.
Cleaning the Dust Cup, Pre-
Filter, and Cyclone Assembly
Cleaning the Multi-Surface
Brush
1. Press the dust cup bottom cover release
button, then empty the contents.
Fig. F-1
1. Turn the lock counterclockwise until it
stops, then remove the roller from the
roller brush.
2. Press the dust cup release button and
remove it from the vacuum.
Fig. F-9
Fig. F-2
3. Remove the pre-filter first, and then
rotate the cyclone system to lift it out.
Fig. F-3
2. Use scissors to cut off the hairs and
fibers that get stuck on the brush roller.
Wipe the dust from the notch and
transparent cover with a dry cloth or paper
towel. Thoroughly dry before use.
Fig. F-10
4. Rinse the cyclone assembly, pre-filter,
and dust cup until they are clean. After
washing, air dry for at least 24 hours.
3. When it is dirty, rinse the brush roller
with clean water until it is clean.
Fig. F-4
Fig. F-11
Note:
• Please clean the dust cup as needed.
4. Stand the brush roller upright for at
least 24 hours until it is fully dry.
• It is recommended to clean the cyclone
Fig. F-12
6