Текст страницы
Spin Mop Head
EN Product Overview
1. Spin Mop Head Release Button
Accessories
2. Outflow Control Switch
1.Extension Rod
Low High Off
2.Combination Tool
3. Water Tank Plug
3.Wide Combination Tool
Fig. B-2
4.Motorized Mini-Brush
5.Illumination Multi-surface Brush
Installation
6.Wall Mount (Including screw ×2, wall plug
Fig. C-1
×2, and mounting template sticker )
7.Charger
8.Spin Mop Head
• It is not recommended to use the
motorized mini-brush with the
extension rod.
9.Mop Pad×4 (pre-installed ×2)
10.Measuring Cup
• Please install the accessories according
to the actual cleaning needs.
Note: The images in this manual are for
illustrative purposes only. The actual
product may differ.
Fig. A
Wall Mount Installation
Diagram
1. Paste the mounting template sticker
Component Names
1.Trigger switch lock
on the wall. The bottom edge of the
mounting template sticker should be
parallel to and about 107cm from the
ground.
When the vacuum is running, press briefly
to switch to discontinuous/continuous
cleaning mode.
2. Use a power drill with an 8 mm drill bit
2.Lock Indicator
3.Suction Level Switch
Turbo
Med
Eco
to drill a hole into each marker on the
mounting template sticker, then insert a
wall plug into each hole.
4.Extension Rod Release Button
3. Align the holes on the mount with the
5.Extension Rod
6.Illumination Multi-surface Brush
holes on the wall. Fasten it to the wall
with the included screws.
7.Antistatic Contact
Fig. C-2
8.Charging Port
Note:
9.LED Battery Status Indicator
10.Battery Release Button
• The wall mount is an optional accessory.
You can install it based on your needs.
11.On/Off Switch
• Press to turn on
• Release to turn off
12.Dust Cup
13.Dust Cup Bottom Cover Release Button
• The wall mount should be installed on a
cool, dry surface with an electrical outlet
nearby. Prior to installing, ensure that
there are no electrical wires or pipes in
the space directly behind installment
position.
14.Brush Release Button
Fig. B-1
15