Текст страницы
EN Charging
Continuous Cleaning Mode when the
vacuum is running. Then release the
on/off switch to make the vacuum in
Continuous Cleaning Mode.
Fully charge the vacuum before using it for
the first time.
Note:
Use the trigger switch lock to free your
fingers and avoid finger fatigue caused by
holding the switch.
• A full charge will take approximately 3.5
hours.
Fig. E-2
Note:
• In this mode, the lock indicator will
illuminate steadily.
• Using Turbo mode for a prolonged
period will cause the battery to heat up,
which increases charging time. Allow
the vacuum to cool down for 30 minutes
before charging it.
• Click the trigger switch lock again to quit
the Continuous Cleaning Mode.
Charging Methods
Charging the vacuum with the charger
Using Different Accessories
Fig. D-1
Illumination Multi-surface Brush
LED Battery Status Indicator
- When using on baby play mats, carpets
or for vacuuming coffee beans, pop corn
and other pellets, turn on the switch on
the brush.
Low battery
Half battery
- When vacuuming on tiles, wooden floors
or other hard surfaces, turn off the switch.
Nearly full
Fig. E-3
Fully charged
Note:
Off
Blinking
On
• The illumination multi-surface brush
can be attached directly to the vacuum.
Note: Once the vacuum is fully charged,
the indicator will turn off after 5 minutes,
and the vacuum will enter the energy-
saving mode.
• When the appliance starts, the
lights in front of the brush roller
will automatically turn on, which is
convenient for use.
Fig. D-2
Motorized Mini-Brush
How to Use
For vacuuming dirt, pet hair, and other
stubborn debris from sofas, bedding, and
other fabric surfaces.
Fig. E-4
Working Methods
Note: It is not recommended to vacuum on
fragile surfaces, such as silk.
Select from two working methods for the
vacuum, based on your needs.
Wide Combination Tool
Method 1: Discontinuous Cleaning Mode
Press and hold the on/off switch to power
it on, and release it to stop immediately.
For vacuuming curtains, keyboards,
ceilings, sofas, vehicle interiors, coffee
tables, etc.
Fig. E-1
Fig.E-5
Method 2: Continuous Cleaning Mode
(Trigger switch lock)
Combination Tool
Click the trigger switch lock to switch to
16