Текст страницы
Press and hold the receiver’s NC button
for 12 seconds to restore
Blinks red slowly for 5 seconds (then
the receiver shuts down)
Low battery
Blinks red quickly
Charging
Solid red
Fully charged in startup state
Lighting effect returns to original
working state
Fully charged in shutdown state
Solid blue
④ USB-C Data Port
For connecting to a computer for upgrades. This port can also be used to charge
the receiver. When the receiver is connected to a mobile phone, this port can
connect to a charging cable to simultaneously charge both the phone and
receiver.
⑤ Charging Contacts
Charging will begin when the charging contacts of the receiver connect to the
charging contacts of the charging case. Once fully charged, the receiver's TX1
indicator will turn solid blue and automatically turn off after 60 seconds.
⑥ M / S Mode Switching Button
The receiver supports two output modes: mono and stereo. You can switch
between them by sliding the M / S mode switching button. Slide to M for mono
mode and slide to S for stereo mode. Note that when the safety track is enabled
in the APP, the output mode will default to mono.
⑦ Expansion Port
The receiver can be connected to a mobile device using the included mobile
device adapter. The receiver can also be mounted onto to a camera when the
receiver belt clip is installed here.
⑧ NC Button
• Press it once to activate or deactivate noise cancellation. There are two levels:
strong and weak. The default setting is strong noise cancellation, which can be
adjusted in the APP. For indoor use, it is recommended to use the weak noise
cancellation.
• After the transmitter and receiver are successfully paired, press and hold the NC
button for 12 seconds. The receiver's indicator will blink red slowly for 5 seconds
before automatically turning off, and the transmitter and receiver will restore their
default settings.
Note: restoring to default settings will only reset the function settings and will not
affect the pairing.
⑨ Power Button
• Press and hold for 2 seconds to power on or off.
• Double press the power button to enable or disable the mobile device’s speaker
function. This function is enabled by default. When the receiver is connected to
your mobile device, you can play back your recordings directly without the need
to unplug.
06