Текст страницы
EN EN How to Use
How to Use
Pause/Sleep
Turn On/Off
Spot Cleaning
Use Mopping Function
It is recommended that all floors are vacuumed at least three times before
the first mopping session to achieve a better cleaning effect.
When the robot is running, press any button to pause it.
If the robot is paused for more than 10 minutes, it automatically enters
sleep mode. All indicators on the robot will turn off. Press any button on
the robot or base station, or use the app to wake up the robot.
When the robot is awaiting, press briefly the button to enable the spot
cleaning mode. In this mode, the robot cleans a square-shaped area of
1.5 x 1.5 meters around it and returns to its starting point once the spot
cleaning is completed.
Press and hold the power button for 3 seconds to turn on the robot. The
power indicator should be illuminated. Place the robot onto the base
station, the robot should turn on automatically and begin charging. To turn
off the robot, remove the robot away from the base station and press and
hold the power button for 3 seconds.
1. Dampen the mop pad and wring out excess water. Install the mop pad as
shown in the diagram.
Robot Restarting
Note:If the robot is paused and placed onto the base station, the current
cleaning process will end.
Fast Mapping
Auto Resume Cleaning
If the robot stops responding or cannot be turned off, press and hold the
power button for 10 seconds to forcefully turn it off. Then, press and hold
the power button for 3 seconds to turn the robot on.
After configuring the network for the first time, follow the instructions in the
app to quickly create a map. The robot will start mapping without cleaning.
When the robot returns to the base station, the mapping process has been
completed and the map will be saved automatically.
If the battery is too low, the robot will automatically return to the base
station to charge. After charging to the appropriate battery level, it will
resume unfinished cleaning tasks.
Start Cleaning
Note: To use this function, please open it in the App.
2. Fill up the tank with water.
Do Not Disturb (DND) Mode
Press the power button to start cleaning after the robot is turned on. The
robot will accurately map out a route, methodically clean along the edges
and walls, then finish by cleaning each room in an S-shaped pattern to
ensure a thorough job.
When the robot is set to Do Not Disturb (DND) mode, the robot will be
prevented from resuming cleaning and the power indicator will turn off.
DND mode is disabled by default at the factory. You can use the app to
enable DND mode or modify the DND period. The DND period is 22:00–
8:00 by default.
Note:
· It is recommended that the robot set out from the base station before
cleaning. Do not move the base station while the robot is cleaning. This
ensures that the robot returns to base station smoothly.
· After the robot completes the cleaning task and automatically returns to
the base station, the base station will start auto-empty. More settings can
be operated on the app.
Note:
· The scheduled cleaning tasks will be performed as usual during the DND
period.
· The robot will resume cleanup where it left off after the DND period
expires.
Note:
· Do not use detergent or disinfectant.
· Do not fill the water tank with hot water as this may cause the water tank
to warp.
14
15