Текст страницы
EN
Before Use
3. Add Water to the Clean Water Tank
1. Set up the Base Station
Place the base station in a location that is as open as possible with a good Wi-Fi
signal. Insert the power cord into the base station and plug it into the socket.
Take out the clean water tank from the base station, and fill it with clean water
up to the max water line. Then install it back into the base station.
Firmly insert the power
cord upwards until the
indicator turns on.
＞5 cm
- MAX -
＞5 cm
＞1,5 m
Note:
MAX Water Line
· Make sure that no objects might block the signaling area.
· To prevent water stains from damaging wood floors or carpets, it is
recommended to place the base station on tile or marble floors.
Note:
· Do not fill the water tank with hot water as this may cause the water tank to warp.
· Do not add any liquid other than the officially-approved cleaning solution to
help prevent base station malfunction.
2. Remove the Protections and Install the Accessories
Remove the sticker and the protective strips on the robot, and then install the
side brush and mop assembly.
4. Place the Robot
Side Brush Clip
Protective Strip
Press and hold the button on the robot for 3 seconds to turn it on. Place
the robot onto the base station with the mop assembly facing toward the
washboard. Then you will hear a voice notification when the robot successfully
connects to the base station and starts charging.
Mop Assembly
Note: It is recommended to fully charge the robot before its first use. When
the robot cannot be turned on after the battery is depleted, manually connect
the robot with the station to charge it.
Note: Install the side brush until it clicks into place.
8