Текст страницы
AUTOMATIC WASHING MACHINE
2. Adjust the position by unscrewing / screwing the legs.
3. Press the opposite corners of the washing machine from the top, make sure that the
washing machine is stable on the surface.
ATTENTION! Do not install the washing machine outdoors or in places with
temperatures below 0°C.
• The legs should be in the lowest possible position (it is not recommended to twist
them to the maximum height).
• The washing machine must stand steadily on a flat, hard floor to minimize vibration,
noise and possible movement of the machine during operation.
• When installing, make sure that there is sufficient space (on all sides) for ventilation
of the washing machine.
CONNECTING THE WATER INLET HOSE
The water pressure level is required for the proper
operation of the washing machine, from 1 to 10 bar
(0.1 – 1 MPa). Install a pressure reducing valve if the
water pressure is higher.
1. Tighten all hose nuts manually.
2. Connect the hose to the water supply, fix it by
screwing on the tap (outlet) of the cold water
supply.
3. Connect the other end of the water supply hose to the inlet valve on the back of the
washing machine and secure the hose.
4. If there is one inlet valve on the back of the washing machine, then it must be
connected to a cold water source.
5. If there are two intake valves, they are connected to cold and hot water supply
sources.
6. Fully open the taps after installing the hose to check for water leaks at the connection
points. If leaks occur, carefully tighten the nuts. To prevent water leakage and
resulting damage, keep the taps closed when the washing machine is not in use.
ATTENTION! Models with one inlet valve should not be connected to the hot
water tap. This may cause damage to the washing machine. Do not use old or used
water supply hoses. This can lead to stains on the underwear.
ATTENTION! Do not bend the hose. Check the connection of the water inlet
hose every time before using the washing machine.
CONNECTING THE WATER DRAIN HOSE
• The drain hose must be located at a height of 60-100 cm above the floor level,
otherwise it may lead to poor slow draining.
• Use the drain hose bracket (not included) for mounting. Make sure that all hose
connections are sealed.
34
USER GUIDE