Текст страницы
AUTOMATIC WASHING MACHINE
- If the hose is positioned incorrectly (less than 40 centimeters above the floor level),
it can make it more difficult to drain the water and the laundry may come out too wet
after washing.
- To prevent water from getting back into the machine and causing problems, make
sure the end of the hose doesn’t sink more than 5 inches into the water. If it’s too long,
you can always shorten it.
ATTENTION! The end of the drain hose must not be submerged in water,
otherwise it may malfunction.
CONNECTION TO THE POWER SUPPLY NETWORK
This appliance is equipped with a grounded plug installed on the power cord. There-
fore, it must be connected to an appropriate electrical outlet to protect against short
circuits. The installation, connection and grounding of the electrical system must comply
with the provisions of European standards, as well as applicable local regulations. The
ground cable must not be interrupted by the switch. If your apartment does not have a
ground connection, contact a qualified electrician to install it.
ATTENTION! The power outlet should be freely accessible, and the washing
machine should be easily connected to the power grid.
• The maximum current when using the washing machine is 16 A, make sure that
the power supply system (current, voltage and wiring) in your home can meet the
requirements of a working washing machine. Make sure that the mains supply
voltage corresponds to the rated voltage of the machine (220V).
• Connect the washing machine to an outlet that is properly grounded. In the event of
a short circuit, grounding can reduce the risk of electric shock. The power plug must
match the power outlet.
• Do not plug in or pull out the plug with wet hands.
• When pulling out the plug, always hold it, carefully removing it from the socket. Do not
pull the power cord.
• If the power cord is damaged, it must be replaced at a service center.
35
USER GUIDE