Текст страницы
10
EN
Notes:
TURNING ON/OFF THE BURNING FLAME
EFFECT
- for example, the room temperature is 25°C, if you use
the buttons (23) «+/-» to set the temperature to 25°C,
in this case the heating element will be switched off
and the room will not be heated, the digital symbols (9)
will show the temperature of «25» degrees, the fan will
work, this will be confirmed by the symbol (10) «
»;
- if the set temperature is 1-2°C higher than the room
temperature, the fan heater will be switched on at the
low power level, while the digital symbols (9) will show
the set temperature, the ventilation mode indicator (10)
«
» and the low power indicator (11) «
»;
• To activate the burning flame effect, press button (7)
«
» on the control panel (4) or button (21)
«
». The burning flame effect will activate on the
front panel of the fan heater (2).
• To deactivate the burning flame effect, press button
(7) «
» on the control panel (4) or button (21)
«
» again. The burning flame effect on the front
panel (2) will turn off.
• After finishing operation, press the power button (6)
«
» on the control panel (4) or the power button
(19) «
» on the remote control (25) to switch the fan
heater to standby mode, and then unplug the power
cord from the electrical outlet.
- if the set temperature is 3°C or more higher than the
room temperature, the fan heater will be switched on
at the high power level, and the digital symbols (9) will
show the set temperature, the ventilation mode indicator
(10) «
» and the high power level indicator (12) «
»;
AUTOMATIC EMERGENCY SWITCH-OFF
FUNCTION IF THE OUTGOING AIR IS TOO
HOT
- when the set temperature equals the room
temperature, the heating element will be switched off,
the fan will be switched off after 30 seconds, the digital
symbols (9) of the set temperature will flash. When the
temperature drops below the set value, the fan heater
will be switched on to heat the room.
• If the outgoing air temperature exceeds the
acceptable value, the automatic thermal switch will
switch on, and the fan heater will be switched off.
• Unplug the unit, let the fan heater cool down for
approximately 15-25 minutes (depending on the air
temperature in the room) and only after that you can
switch the unit on again.
• Make sure that the front (3) and rear grids are not
blocked with foreign objects.