Текст страницы
8
EN
• Do not place the fan heater on soft surfaces, such as
carpets with high pile, sofas or beds.
• Make sure the distance between the front air outlet
grid and any surrounding objects is at least 1.0 m.
• To avoid mains overloading, do not switch on several
electrical appliances with high power consumption at
the same time.
REMOTE CONTROL (25)
-
remove the used battery from the remote control
(25) and dispose of it.
• When using the remote control, aim it at the front of
the body of the fan heater.
• The distance between the remote control and the fan
heater should not exceed 5 m, the coverage angle
should be up to 30 degrees.
• Avoid exposing the receiver to direct sunlight,
as it may cause unintended activation of control
commands.
ATTENTION!
SWITCHING THE FAN HEATER ON
A lithium battery is used in the remote control. To
avoid danger, do not allow children to play with the
battery. If your child has swallowed a battery,
immediately see a doctor.
BATTERY INSTALLATION/REPLACING (FIG. 4)
• Insert the power plug into the mains socket, you will
hear a sound signal and the fan heater will be turned
into the standby mode, the room temperature will be
shown by digital symbols (9).
• Switch the fan heater on by pressing the on/off button
(6) «
» on the control panel (4) or the button (19)
«
» on the remote control (25), the fan heater will
be switched on in ventilation mode, the symbol (10)
«
» will light up, and the digital symbols (9) will
show the air temperature in the room. To switch the
fan heater off, press the on/off button (6) «
» on
the control panel (4) or the button (19) «
» on the
remote control (25), and the fan heater will be turned
into the standby mode.
• Note: — the temperature digital symbols (9) may
differ slightly from those of another thermometer.
• Press on the clamp and remove the battery holder
(24) from the remote control (25) body, insert a
CR2025 battery (not supplied with the unit) into the
holder, strictly following the polarity.
• Install the battery holder (24) into the remote control
(25).
• Notes:
-
if there is an insulating insert in the battery holder
(24), remove the insert;
-
replace the battery in a timely manner;
-
do not recharge the lithium battery;
-
remove the battery if you are not going to use the
unit for an extended period;