Текст страницы
10
EN
ATTENTION! Be careful when pouring out water to
avoid burns by hot water.
• It is not recommended to consume the hot water
obtained from the initial boiling for food, you can use
it for household needs.
USING THE THERMOPOT
• Press button (15) « » to set the desired water
temperature: 45, 55, 65, 75, 85, 100°C, or 000 (room
temperature). The set water temperature will be
displayed via digital indication (19).
• Press the button (13) «
» to start dispensing water.
Water will start flowing continuously from the spout
(3) after 5-10 seconds. Press the button (13) «
»
again to stop the water flow.
Note: in the water supply mode for preparing baby food,
water is supplied by pressing and holding the button
(17) « », when you pour the required amount of water,
release the button (17) « ».
WARNING! To avoid the risk of burns, always check
the temperature of baby food before giving it to
your baby. You can easily check the temperature
of baby food by placing a few drops on the back of
your hand.
ATTENTION! Be careful when pouring water into the
cup to avoid burns by hot water.
• • Place the thermo pot on a dry flat surface keeping
at least 20 cm gap between the thermo pot body and
the wall or furniture and at least 50 cm of free space
above the thermo pot.
• Fill the thermopot with water using suitable
containers, but do not exceed the maximum water
level mark. Do not fill the thermopot with water
directly from the faucet; to fill the thermopot use a
suitable bowl.
• You can remove the water tank (6) and fill it with
water (Fig. 1), replace the tank (6) and close it with
the lid (5).
• Insert the power cord plug into the mains socket.
• Place a cup of the required volume onto the grid (2)
of the removable drip tray (1), make sure that the cup
is under the water drain spout (3).
• To unlock the thermo pot, press and hold down the
• When there is no water in the reservoir (6), you
will hear a sound signal, error code E7 will flash,
and a flashing «
» indicator (11) will appear. Refill
the reservoir (6) with water and continue using the
thermo pot.
button (16) «
» for about 3-5 seconds.
• Press button (14) «
» to set the desired water
volume: 100 ml, 200 ml, 300 ml, 400 ml, or 000
(continuous water flow). The selected water volume
will be displayed via digital indication (18).
instr BR6001.indd 10
instr BR6001.indd 10
15.07.2024 10:38:55
15.07.2024 10:38:55