Текст страницы
8
EN
• Unpack the thermopot and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the thermopot for damages, in case of
damage do not plug it into the mains.
• Make sure that the specifications of power supply
voltage specified on the label correspond to the
specifications of your mains. When using the
thermopot in the mains with 60 Hz frequency, the unit
does not need any additional measures.
• Wipe the outer surface of the unit body with a clean,
slightly damp cloth to remove dust.
• Remove the lid (5).
• Remove the water tank (6).
• Wipe the water tank (6) inner surface with a clean,
slightly damp cloth to remove dust. Close the lid (5).
Removing mineral deposits).
• «11» No water in reservoir indicator « », when there
is no water in the reservoir (6), you will hear a sound
signal, error code E7 will flash, and a flashing «
»
indicator (11) will appear. Refill the reservoir (6) with
water and continue using the thermo pot.
• «12» Descaling mode button « ». After using the
thermo pot for 10 hours, the «
» indicator (10) will
start flashing, indicating the need for descaling (see
the Descaling section).
• «14» Water volume selection button «
»: Press the
button (14) «
» to set the desired water volume:
100 ml, 200 ml, 300 ml, 400 ml, or 000 (continuous
water flow). The selected water volume will be
displayed via digital indication (18).
• «13» Power/water dispense button «
»: To
dispense water, press the button (13) «
». Water
will start flowing continuously from the spout (3)
after 5-10 seconds. To stop the water flow, press the
button (13) «
» again.
CONTROL PANEL
• «16» Lock Button «
»: To unlock the thermo pot,
Before using the thermopot, familiarize yourself
with the functions of the buttons on the control
panel (4).
press and hold down the button (16) «
» for about
3-5 seconds. If no actions are taken within 10-15
seconds, the thermo pot will automatically lock. To
manually lock the thermo pot, press the lock button
• «10» Indicator of the need for descaling «Descaling»,
after using the thermopot for 10 hours, the indicator
(10) «
» will flash, this means that it is necessary
to clean off mineral deposits (scale) (see section
(16) «
».
• «15» Temperature setting button « »: Press the
button (15) « » to set the desired water temperature:
instr BR6001.indd 8
instr BR6001.indd 8
15.07.2024 10:38:55
15.07.2024 10:38:55