Текст страницы
9
EN
level mark. Do not fill the thermopot with water
directly from the faucet; to fill the thermopot use a
suitable bowl.
• You can remove the water tank (6) and fill it with
water (Fig. 1), replace the tank (6) and close it with
the lid (5).
Notes: to reduce the mineral deposit (scale), we
recommend using the water cleaned with domestic
filters.
45, 55, 65, 75, 85, 100°C, or 000 (room temperature).
The set water temperature will be displayed via
digital indication (19).
• «17» Water supply button for preparing baby formula
« », put the baby formula into a bottle or cup, press
and hold the button (17) « », the temperature 40°C
will be displayed in digital symbols (19), hold the
button (17) « » until you have poured the required
amount of water, then release the « » button (17).
• Insert the power cord plug into the mains socket.
• Place a cup with a volume of at least 200 ml on the
grid (2) of the removable drip tray (1), make sure that
the cup is under the spout for pouring water (3).
• To unlock the thermo pot, press and hold down the
ATTENTION! In the water supply mode for preparing
baby food, at all temperature settings, the water does
not boil in advance, therefore, when preparing baby
food, it is recommended to first boil and then cool the
water to room temperature, pour it into the tank (6) and
use it.
• «18» In digital symbols (18) the set water supply
volume is displayed.
• «19» In digital symbols (19) the set water supply
temperature is displayed.
THE FIRST USE
button (16) «
» for about 3-5 seconds.
• Press button (14) «
» to set the water volume: 200
ml - the set water volume will be displayed via digital
indication (18).
• Press the button (15) « » to set the water
temperature: 100°C - the set water temperature will
be displayed via digital indication (19).
• To start dispensing water, press the button (13) «
». Water will start flowing continuously from the spout
(3) after 5-10 seconds. To stop the water flow, press
the button (13) «
» again.
• After filling the cup with hot water for the first time,
drain the water and fill and drain the hot water from
the cup one or two more times.
• Place the thermopot on a dry flat surface keeping at
least 20 cm gap between the thermopot body and
the wall or furniture and at least 50 cm gap above the
thermopot.
• Remove the lid (5) (pic. 1).
• Fill the thermopot with water using suitable
containers but do not exceed the maximum water
instr BR6001.indd 9
instr BR6001.indd 9
15.07.2024 10:38:55
15.07.2024 10:38:55