Текст страницы
Filling Clean Water Tank
OPERATION
1.Press the Clean Water Tank release button to
Preparing for Use
EN
remove it from the appliance.
Fig.C-4
2.Open the tank cap, and fill with tap water
• Before first use, please charge the appliance
for 4-5 hours (refer to “Charging Instructions”
for details).
* Based on results from Tineco lab tests. Lab
temperature 39.2°F (4°C) ~ 104°F (40°C).
to the Max line. When deep cleaning is
necessary, add one bottle cap of solution to
the CWT and tightly close the cap.
Fig.C-5
Note:
Only use water under 140°F/60°C.
DO NOT USE HOT WATER.
3.Place the tank back into the appliance. You
1.Press the
button and the appliance will
start in AUTO mode by default. Press it again
to turn off the appliance. Switch between
AUTO, MAX and SUCTION modes by
pressing the
button.
Fig.C-1
should hear a “Click” if done correctly.
Fig.C-6
Charging Instructions
To charge the appliance, place the appliance
on the charging dock and plug the adaptor into
a power outlet.
1.To charge the appliance, connect the external
Tips (SUCTION mode not available):
• Solution mode/ Water Only mode:
Appliance starts with Solution mode by
default. Power on while the appliance is
upright, hold
for 3s to switch between the
two modes.
• Switch to Water Only mode:
LED Loop: Red → Blue (use water only)
• Switch to Solution mode:
LED Loop: Blue → Red (use cleaning solution)
charging cord to the charging dock and plug
it into the wall outlet.
2.To avoid tripping hazards, please place the
2.The appliance will stop working when put
appliance on the charging dock near a wall
during charging.
Fig.C-7
upright and start running again when reclined.
* Do not recline more than 142° to avoid water
leakage.
Fig.C-2
3.Place the appliance on the charging dock
vertically after use for recharge and storage.
Fig.C-3
Note:
• The cooling system has been activated to
optimize battery charging with a slight sound.
• During charging, hold the
button for
10 seconds to turn on/off the cooling system.
Note:
• It is crucial to choose the right mode based
on the CWT contents to achieve the highest
level of dirt detection efficiency.
• Do not vacuum foamed liquid.
• To vacuum water left on the surface, the
appliance will keep running for 3 seconds
after power off.
• Suction mode is only available in selected
models, please refer to the actual product.
Warning:
• Only charge the appliance with the adaptor
supplied by Tineco.
• During long periods of not being used, the
appliance must be charged once every
3 months for optimal performance. It may take
4-5 hours for a full charge.
• Store indoors in a dry place. Do not expose
the appliance to sunlight or freezing
temperatures. Recommended temperature
range: 39.2°F (4°C) ~ 104°F (40°C).
10