Текст страницы
FAQ
Q1. I cannot access the web UI of the AP after entering
192.168.0.254. What should I do?
A1. Try the following solutions:
Check if your Ethernet cables are connected properly. If
yes, the LED indicator lights up.
Ensure that the IP address of your computer has been set to
192.168.0. ( : 2 to 253), and the IP address is not used by
any other devices in the network.
Clear the cache of your web browser, or try with another
web browser.
Disable the firewall of your computer, or try with another
computer.
If two or more APs are connected in the network without an
AP controller, you should leave only one AP in the network
first and configure the AP’s IP address. Then repeat this
procedure to change the IP addresses of other APs.
Meanwhile, ensure that the APs’ new IP addresses are in
the same network segment with the IP address of your
computer. Then try logging in to the APs’ web UI using their
new IP addresses.
The AP may be being managed by an AC and therefore its
IP address is no longer 192.168.0.254. In this case, go to
the web UI of the AC to view the new IP address of the AP,
and then log in to the AP’s web UI using the new IP address.
If the problem persists, reset the AP.