Текст страницы
CLEANING AND MAINTENANCE
Before cleaning, remove the plug from the socket and allow the iron to
cool down sufficiently.
1. Wipe off the soleplate with a damp cloth and a non-abrasive (liquid)
cleaner.
2. If the fiber is adhered to the soleplate, use a damp cloth with vinegar to
wipe off the soleplate.
3. Never use strong acid or alkali in order to avoid damaging the soleplate.
4. If the scale blocks the steam hole, please remove the scale with
toothpick; do not damage the surface of soleplate.
5. Stand the iron on its end and let it cool down sufficiently, and meantime
pour any remaining water out of the box, set the dry/steam selector to
position “O”.
TROUBLESHOOTING
Problem
Possible Reasons
Measurement
Not enough heat or Too
heat
Rotate Fabric Select Dial improperly or
unplugging
Correct Fabric Select Dial in
position and check if the iron is
plugged.
No steam or Leakage
The Fabric Select Dial has been set to
MIN
Set the Fabric Select Dial to the
required position.
No surge of steam or
no vertical steam
The(vertical) surge of steam function has
been used too often within a very
short period. The iron is not hot
enough
Continue ironing in horizontal
position and wait a while
before using the (vertical)
surge of steam function again
Set the Fabric Select Dial out of steam
range.
Set the Fabric Select Dial as per
steam range.
Leaking water from
Soleplate
The heat is still not enough.
Open Dry/Steam Selector only
after the indicator light goes off.
The water is over than max position
Pour out the remaining water
Little Steam
Check if the Dry/Steam Selector is in
proper location.
Set the steam knob to the proper
location.
Steam hole is blocked.
Clean hole with distilled water.
Too little water in the water tank
Fill water into the box
No Spraying
No enough pressure or air inside
Press the spray nozzle by hand,
and push the spray button
several times continuously.
9