Инструкция IP-камера Tiandy TC-C34XN I3W/E/Y/2.8mm/V4.2

Installation Diagram of HD Network Safe (Non-) IR Dome Camera-V2.0

Steps:

1. Mark the mounting hole position of camera on the wall with a ink pen or positioning sticker, make

holes on the indicated hole position with a electric drill, and drive the expansion rubber plug into the

hole.

2. For models without a tail cable: loosen the screws, remove the dome housing, pass the power cord,

audio cable (optional) and network cable through the cable hole plug at the base of dome, with a

cable diameter of 3-5mm (Note: pull back after passing the cable to ensure water resistance), and

then fasten the base of dome to the wall or ceiling. Connect the power cable and audio cable

(optional) to the corresponding interface of camera. After making the plug of the network cable,

insert it into the Ethernet interface of camera, and then fasten the base of dome base to the wall or

ceiling.

3. For models with a tail cable: connect the power supply, network cable and other parts to the

29