Инструкция IP-камера Tiandy TC-C32QN I5W/E/Y/4mm/V4.2

3.2.5. HD Network Safe (Non-) IR Dome Camera

Installation Diagram of (Non-) Safe IR Dome Camera -V1.0

Steps:

1. Mark the positions of holes for mounting camera on the wall using an ink pen. Make holes on the

marked positions using an electric drill, drive the expansion rubber plug into the hole.

2. Take out the camera in the packaging box, and remove the dome cover; and then fasten the dome

to the ceiling using mounting screws.

3. Loosen the adjusting screw, adjust the camera lens to an appropriate angle, and then re-fasten the

adjusting screw.

4. Align the dome cover with the mounting position of the base, and then fasten it by turning.

5. Finally, remove the protective film on the dome cover (please protect the transparent cover of

dome, to avoid oil stains and scratches).

Note:

(1) The mounting surface of camera must have sufficient bearing capacity.

(2) Please use the dome camera as soon as possible after unpacking.

(3) Fog may be caused when disassembling the equipment in wet environments.

(4) To ensure the waterproof effect, please tighten the screws.

28