Текст страницы
Operation
■ STARTING ENGINE
• Hold the upper end of the control arm in hand
IMPORTANT
•
Avoid pulling the starter rope out to its full extent
and allowing the starter rope to snap back. This
will prevent premature damage to the starter.
and, while pulling it away from the unit, rotate
arm forward (anti-clockwise as the arrow
direction) until it clicks. To fold the arm, reverse
the order.
5. Once the engine is running, gradually open the
choke if it was set closed, and let the engine run
at idle speed for a minute to warm it up.
NOTE
When the engine fails to start after several attempts
due to overchoking, open the choke and repeat
pulling the rope.
1. Push the primer bulb until fuel flows out in the
■ ADJUSTING IDLE SPEED
•
The idling speed is set for 2000 rpm at the
factory. If it is necessary to adjust the idle speed,
use the adjustment screw on the top side of
carburetor.
clear tube.
2. When the engine is cool, close the choke.
(1)
(1)Idling adjustment screw
(1)Choke lever
(2)Primer bulb
(3)CLOSE
(4)OPEN
3. Set the throttle lever in 1/3 open position.
■ STOPPING ENGINE
•
Move the throttle lever to the idling position
and press the stop switch (red button) until the
engine comes to a complete stop.
(1)
(1)
(2)
(3)
(1) Stop switch
(1)Full Throttle
(2)About 1/3 Open
(3)Idling
4. To start, hold the top of the mister firmly with
your left hand. Pull the starter knob slowly until
you feel it engage and then give it a vigorous
strong pull.
10 - English