Текст страницы
Care and cleaning
1.
Turn off the machine using
and remove the plug from the wall socket.
2.
Remove the coarse filter and the fine filter.
3.
Scoop out the water from the dishwasher tub.
4.
In order to inspect the drainage pump, remove the yellow drainage pump stop on the right in
the bottom drain. (Use a pair of pliers if necessary.)
5.
Turn the pump wheel located behind the drainage pump stop by hand. Carefully remove any
sharp items, such as glass.
6.
Refit the drainage pump stop along with the fine and coarse filters.
7.
Plug the machine in again.
Drainage pump
stop
NOTE!
Do not forget to refit the drainage pump stop.
Unblocking the inlet hose filter
If the water supply contains small particles, the outer filter on the inlet hose may become blocked,
which results in the Water inlet fault error message.
1.
Turn off the machine using
and remove the plug from the wall socket.
2.
Turn off the water tap.
3.
Unscrew the inlet hose.
4.
Carefully remove the outer filter from the inlet hose and clean it.
5.
Refit the filter and check that the gasket is correctly positioned.
6.
Screw the inlet hose firmly into place.
7.
Plug the machine into the wall socket and turn on the water tap. Allow the pressure to settle for
a while and check that the connection is watertight.
Outer filter on
inlet hose
Gasket
34