Текст страницы
Product Specification Model No.: GP210AAHC Document Number: MQS3553 Revision: 03 Page 4 of 5
Test
Unit
Specification
Conditions
Remarks
External Short
Circuit
N/A
No fire and no
explosion.
After standard charge,
short circuit the cell(s) at
20+/-5℃ until the cell(s)
temperature returns to
ambient temperature. (The
resistance of the inter-
connecting circuitry shall
not exceed 0.1Ω.)
Unit cell
Vibration
Resistance
N/A
Change of voltage
should be under
0.02V/cell,
Change of impedance
should be under
5 milli-ohm/cell.
Charge the battery 0.1C
16hrs, then leave for
24hrs, check battery
before / after vibration,
Amplitude: 1.5mm
Vibration: 3000CPM
Any direction for 60mins.
Unit cell
Impact
Resistance
N/A
Change of voltage
should be under
0.02V/cell,
Change of impedance
should be under
5 milli-ohm/cell.
Charge the battery 0.1C
16hrs, then leave for
24hrs, check battery
before / after dropped,
Height: 50cm
Wooden board
(thickness 30mm)
Direction not specified,
3 times.
4. CONFIGURATION, DIMENSIONS AND MARKINGS
Please refer to the attached data sheet.
5. EXTERNAL APPEARANCE
The cell / battery shall be free from cracks, scars, breakage, rust, discoloration, leakage nor deformation.
6. WARRANTY
One year limited warranty against workmanship and material defects.
7. CAUTION
1. Batteries should be charged prior to use.
2. For charging methods please referred to our technical handbook.
3. Use the correct charger for Ni-Cd or Ni-MH batteries.
4. Do not reverse charge batteries..
5. Do not subject batteries to adverse condition such as extreme temperature, deep cycling and excessive
over charge/over discharge.
Manufacturer reserves the right to alter or amend the design, model and specification without prior notice.