Текст страницы
Product Specification Model No.: GP210AAHC Document Number: MQS3553 Revision: 03 Page 5 of 5
6. Avoid batteries being used in an airtight compartment. Ventilation should be provided inside the battery
compartment; otherwise batteries may generate hydrogen gas, which could cause an explosion if exposed to
an ignition source..
7. Do not attempt to take batteries apart or subject them to pressure or impact. Heat may be generated or fire
may result. The alkaline electrolyte is harmful to eyes and skin, and it may damage clothing upon contact.
8. Keep away from children. If swallowed, contact a physician at once.
9. Do not short circuit batteries, permanent damage to batteries may result.
10. Do not incinerate or mutilate batteries, may burst or release toxic material.
11. Do not solder directly to cells or batteries.
12. Store batteries in a cool dry place.
13. If find any noise, excessive temperature or leakage from a battery, please stop its use.
14. When not using a battery, disconnect it from the device.
15. When using a new battery for the first time or after long term storage, please fully charge the battery before
use.
16. Do not mix new batteries in use with semi-used batteries, over-discharge may occur.
17. When connecting a battery pack to a charger, ensure correct polarity.
18. When the battery is hot, please do not touch it and handle it, until it has cooled down.
19. Do not remove the outer sleeve from a battery pack nor cut into its housing.
20. When find battery power down during use, please switch off the device to avoid over discharge.
21. Unplug a battery by holding the connector itself and not by pulling at its cord.
22. After use, if the battery is hot. Before recharging it, allow it to cool in a well-ventilated place out of direct
sunlight.
23. Never put a battery into water or seawater.
24. In order to maintain satisfactory cell/battery performance when being stored under extending period of time,
cycling (i.e. charging and discharging) of the cell / battery within 12 months period is highly recommended.
At least one times cycling should be conducted within 15 months.
__________________________________________________________________________________
Notes : 1. Ta: Ambient Temperature
2. Approximate charge time from discharged state, for reference only.
3. IEC61951-2(2011) 7.5.1.2 Endurance in cycles:
Cycle No.
Charge
Rest
Discharge
1
0.1C x 16hrs
none
0.25C x 2hrs20mins
2 - 48
0.25C x 3hrs10mins
none
0.25C x 2hrs20mins
49
0.25C x 3hrs10mins
none
0.25C to 1.0V / cell
50
0.1C x 16hrs
1- 4hr(s)
0.2C to 1.0V / cell
Cycles 1 to 50 shall be repeated until the discharge duration on any 50th cycle becomes less than 3hrs
Manufacturer reserves the right to alter or amend the design, model and specification without prior notice.