Текст страницы
1.5
Replacing the card bracket
The PEI-10G/82599-2S Ethernet card is bundled with a full-length bracket, a low-profile
bracket, and an ASUS proprietary bracket. By default, the card is pre-installed with a full-
length bracket.
The proprietray bracket supports ASUS Z10PH-D16 series, ESC4000 G3 series, and
RS720Q-E8 series models, etc. The supported list of models are subject to change without
prior notice.
To replace the card bracket:
1.
Get the PEI-10G/82599-2S Ethernet card and place it on a stable and flat surface.
Ensure that the printed circuit board (PCB) is facing down.
2.
Remove the two screws that secures the PEI-10G/82599-2S Ethernet card to the card
bracket then remove the card bracket.
Screw
Default card bracket
Screw
3.
Get the replacement card bracket.
4.
Align and insert the PEI-10G/82599-2S Ethernet card into the mounting hole of the card
bracket. Ensure that the screw holes on the PEI-10G/82599-2S Ethernet card matches
the screw holes of the card bracket.
5.
Replace the screws that you removed earlier in step 2.
Screw
Replacement card bracket
Screw
1-4
Chapter 1: Product introduction