Текст страницы
2.3
Intel(R) Ethernet Flash Firmware Utility
The Intel(R) Ethernet Flash Firmware Utility allows you to switch between PXE option ROM
and iSCSI option ROM. Note that only one option ROM can be used at a time.
To start the Intel(R) Ethernet Flash Firmware Utility:
1.
Turn on the system.
2.
Enter DOS enviroment.
The utility must run under pure DOS environment. It cannot run in a DOS box on Windows
system. You should boot from a DOS floppy without any device drivers
3.
Within the DOS enviroment, enter the directory with the bootutil file.
4.
Check the MAC address of the corresponding LAN card:
bootutil -E
C:\>bootutil -E
Intel(R) Ethernet Flash Firmware Utility
BootUtil version 1.5.22.2
Copyright(c) 2003-2014 Intel Corporation
NIC= 1 MACAddress=00E018122208
NIC= 2 MACAddress=00E018122209
NIC= 3 MACAddress=00E01803016C
NIC= 4 MACAddress=00E01803016D
NIC= 5 MACAddress=00E01803016E
NIC= 6 MACAddress=00E01803016F
Port Network Address Location Series WOL Flash Firmware Version
==== =============== ======== ======= === ============================= =======
1 00E018122208 1:00.0 10GbE N/A PXE 2.3.27
2 00E018122209 1:00.1 10GbE N/A PXE 2.3.27
3 00E01803016C 8:00.0 Gigabit YES FLASH Not Present
4 00E01803016D 9:00.0 Gigabit YES FLASH Not Present
5 00E01803016E 10:00.0 Gigabit YES FLASH Not Present
6 00E01803016F 11:00.0 Gigabit YES FLASH Not Present
C:\>
5.
Install the PXE option ROM:
bootutil -nic=1 -up=pxe+efi -quiet
or
Install the iSCSI option ROM:
bootutil -nic=1 -up=iscsi -quiet
Port 1 and Port 2 share the same flash.
6.
Restart the system.
2-6
Chapter 2: Boot Agent Configuration