Текст страницы
●PoC power supply is with high voltage. Do not dismantle the device during normal operation;
otherwise it might cause danger to both device and users due to high voltage.
●Do not connect the non-PoC camera to a PoC XVR, otherwise it might damage the camera.
PoC camera can be divided into AT camera and AF camera. Power consumption of AT camera is less
than 12 W, and power consumption of AF camera is less than 6 W.
You need to check the maximum power of PoC before use. Assuming that the maximum power of
one XVR is 48 W, the XVR can connect AT cameras up to 48/12=4 and AF cameras up to 48/6=8.
10.3 Long Distance Power Supply
In many scenarios, our clients adopt long distance power supply, transmitting 12 VDC to cameras
located over 100 m. Such long distance power supply might cause problems.
Q1: Recurrent restart of devices or even ICR Failure.
Possible reasons: The long power supply cable leads to a large voltage drop on the equipment
power supply cable, and turning on the IR light at night leads to a further increase of the voltage
drop, resulting in restart of the device. After the device is restarted, the ICR is switched to the Day
mode by default. By judging the ambient light at night, the device will operate in Night mode, and
then the infrared light is turned on, which causes the device to restart again because of
undervoltage. Thus, ICR is switched to every 2 seconds, impacting its switching lifespan.
Q2: Unable to restart devices at night, and black screen or restart occurs when switching ICR.
Possible reasons: The long power supply cable leads to a large voltage drop on the equipment
power supply cable, and turning on the IR light at night leads to a further increase of the voltage
drop, resulting in restart of the device and black screen.
Solution: During construction, when the camera location is far from the power supply, you need to
adopt long distance separate power supply or purchase –DP dual power supply to use 24 VAC
power supply.
10.4 Centralized Power Supply
The typical problem of centralized power supply is that there are obvious black stripes on the
device screen, which interferes with the display.
The principle of centralized power supply is as follows:
33