Текст страницы
5 How to use the hob
• If the gas does not ignite after you press and
As a counter measure against blow out due to fluid
overflows at burners, safety mechanism trips and
shuts off the gas.
• Push the knob inwards and turn it counter clock
wise to ignite.
• After the gas ignites, keep the knob pressed for
3-5 seconds more to engage the safety system.
release the knob, repeat the same procedure by keeping the knob pressed for 15 seconds. A
Release the button if the burner is
not ignited within 15 seconds. Wait
at least 1 minute before trying again.
There is the risk of gas accumulation
and explosion!
6 Maintenance and care
• The surface might get damaged
6.1 General information
Service life of the product will extend and the pos
sibility of problems will decrease if the product is
cleaned at regular intervals.
• Disconnect the product from
C
mains supply before starting
maintenance and cleaning works.
There is the risk of electric shock!
A
• Allow the product to cool down be
by some detergents or cleaning
materials. Do not use aggressive
detergents, cleaning powders/
creams or any sharp objects dur
ing cleaning. Do not use harsh
abrasive cleaners or sharp metal
scrapers to clean the oven door
glass since they can scratch the
surface, which may result in shat
tering of the glass.
• Do not use steam cleaners to
fore you clean it. Hot surfaces may
cause burns!
• Clean the product thoroughly after each use. In
clean the appliance as this may
cause an electric shock.
this way it will be possible to remove cooking
residues more easily, thus avoiding these from
burning the next time the appliance is used.
6.2 Cleaning the hob
• No special cleaning agents are required for
Cleaning the burner
1. Remove the saucepan carriers from the hob.
2. Remove all removable parts of the burner and
cleaning the product. Use warm water with
washing liquid, a soft cloth or sponge to clean
the product and wipe it with a dry cloth.
• Always ensure any excess liquid is thoroughly
clean only by hand with sponge, some detergent
and hot water.
3. Clean the non-removable parts of the burner
wiped off after cleaning and any spillage is im
mediately wiped dry.
with a wet cloth.
• Do not use cleaning agents that contain acid or
4. Clean the plug and thermal element (in models
chloride to clean the stainless or inox surfaces
and the handle. Use a soft cloth with a liquid de
tergent (not abrasive) to wipe those parts clean,
paying attention to sweep in one direction.
with ignition and thermal element) with a slightly
moist cloth. Afterwards, dry with a clean cloth.
Make sure that flame holes and plug are total
ly dry. Otherwise, no spark occurs at the end of
ignition.
5. When placing the pan supports, pay attention to
place the pan supports so that the burners are
centered.
Built-in Hob / User Manual
25 / EN