Текст страницы
EN
EN
Routine Maintenance
Routine Maintenance
Dust Box and Filter
Used Water Tank
Robot Sensors
Charging Contacts and Signaling Area
1. Open the robot cover and press the dust box clip to remove the dust box.
Clean the charging contacts and the signaling area with a soft and dry cloth.
1. Remove the used water tank, open its cover and pour out the used water.
Wipe the robot sensors by using a soft and dry cloth, as shown in the below
figure:
Bumper Window
Laser Distance Sensor (LDS)
2. Remove the dust box filter, and then empty the dust box.
2. Rinse the used water tank with clean water, and use a proper tool to clean
the inner wall of the used water tank.
Bumper
Edge Sensor
3. Gently tap the basket of the filter to remove the dirt.
Auto-empty Vents
Cliff Sensors
Clean the auto-empty vents of the robot and the base station with a soft and
dry cloth.
Carpet Sensor
Note: Do not attempt to clean the filter with a brush, a finger or sharp objects to prevent
damage.
Note: The float ball in the used water tank is a movable part. Do not apply too much force
4. Rinse the dust box and filter with water and dry them completely before
reinstalling.
when cleaning it to avoid damaging it.
24h
Note:
Note: A wet cloth can damage sensitive elements within the robot and the base station.
Please use a dry cloth for cleaning.
- Rinse the dust box and filter with clean water only. Do not use any detergent.
- Use the dust box and filter only when they are completely dry.
14
15