Текст страницы
GAS STOVE
CONTROL PANEL
To light the burners, use the electric ignition button with the symbol
. Hold down the
electric ignition button and simultaneously press the knob of the burner you need, turn the
knob until the desired flame strength is set, then release the button and the knob. To turn off
the hotplate, set the control knob to the position .
- the lack of gas supply
- maximum gas supply - minimum gas supply
Power control of the burner is as follows:
1. To install the flame to maximum power, turn the handle counterclockwise from « » to «
»
(move the pointer to the required position).
2. To set the minimum power flame, turn the knobs clockwise from the « » position to the
« » position (place the pointer in the desired position).
To ignite the oven, you need to press and hold the corresponding knob for 5 –10 seconds.
Then press the electric ignition button. After igniting the burner, you must additionally hold the
handle for 10 –15 seconds. Then the handle can be released, and the burner will continue to
burn independently. If the burner does not ignite, repeat the previous steps. After the burner is
lit, the oven door can be closed in 2 minutes. You can turn the light bulb on and off using the
light switch for internal oven lighting (the control panel may differ depending on the model).
INSTALLATION AND CONNECTION
ATTENTION! The appliance must be installed by a qualified installer who is familiar with
the current installation rules.
• This product should be installed and used in strict accordance with the instructions in this
manual and with applicable state and local standards and regulations.
• The room must be well ventilated, with ventilation installed, make sure that it is well ventilated.
Consult your qualified installer if you are not sure what kind of ventilation you will need.
• Vents must have a cross-section of at least 100 cm and must be protected from accidental
blocking (protection with metal bars or nets). Make sure that there is no other furniture
behind the back of the stove.
• The air flow between the adjacent room and the room where the appliance is installed must
be free through permanent openings (which can be obtained by increasing the gap between
the door and the floor).
• The stove must be installed steadily on a flat surface away from heating appliances and
materials. A note about the installation of the plate must be made in the "Installation Card".
• All furniture adjacent to the gas stove must withstand a temperature of at least 85°C above
the average room temperature. The distance to the adjacent walls and kitchen furniture
should be at least 2 cm. The height from the gas stove to the hood must be at least 65 cm.
26
USER GUIDE