Инструкция IP-камера Tiandy TC-C35US

corresponding interface of camera. Loosen the screws, remove the dome housing, and fasten the base

of dome to the wall or ceiling.

4. Adjust the lens to the required scene, and then tighten the two mounting screws. The

recommended torque is 6-7kgf.cm.

5. Before installing the equipment in a humid environment, please replace the desiccant and then

fasten the dome housing to the base of dome, and finally remove the protective film on the housing

(Note: do not crimp when installing dome housing on the base).

Note:

(1) The mounting surface of camera must have sufficient bearing capacity.

(2) Fog may be caused when disassembling the equipment in wet environments.

(3) To ensure the waterproof effect, please tighten the screws.

3.2.6. HD Network Gun Camera

Installation Diagram of HD Network Gun Camera

Steps:

1. Mark the positions of holes for mounting camera on the wall using an ink pen.

2. Make holes on the marked positions using an electric drill.

30