Текст страницы
Air Compressor
the graphic pages.
1. Electric motor
2. Switch
3. Safety valve
4. Outlet fftting
5. Pressure gauge
6. Check valve
7. Condensate drain valve
8. Transport wheels
9. Air duct
10. Air tank(receiver)
11. Protective cover
12. Thermal relay cocking button
13. Air fflter
14. Oil breather
15. Oil ffller plug
16. Pressure switch
17. Pressure regulator
18. Oil level indicator
Technical Data
rect operation and good lubrication of all its
parts.
Do not fix the product tightly to the floor,
otherwise it will prevent its normal vibration
during operation.
Connect the product to the mains only when
you are ready for use.
Make sure that your mains voltage matches
the rated voltage of the product. Use the
product only in networks that have an earth
conductor.
Before using the product for the first time, to
ensure good distribution of the lubricant, turn
on the compressor, open the tap and let it run
for 5-8 minutes.
Attention! If necessary, in order to avoid
unwanted breakage, before the first start of
the compressor, it is necessary to replace the
plug on the crankcase lid with a special plug
(breather) supplied in the kit.
Attention! Before the first start, check the in
stallation of the air filter.
Preparation for work
The product is supplied without oil.
Filling the product with oil:
►Check for oil in the crankcase. The oil level
is monitored using an indicator. If the oil
level is sufficient (in the middle of the indi
cator), do not add oil.
►At the first start-up after purchase: Fill in
oil of the appropriate type (see below), vis
cosity and check the oil level;
►On subsequent starts: if the oil level is
insufficient, add oil corresponding to the
grade already filled;
Note! To avoid engine damage, never mix dif
ferent brands of oil.
►Prepare special oil for compressors;
►Unscrew the oil filler cap;
►Fill in the amount of oil approximately
Model
PAC50-C2
Rated voltage
220 V~/50 Hz
Rated power
2200 W
Receiver volume
50 L
Output
420 L/min
Operating pressure
8 bar
Weight
37 kg
Contents of delivery
Air compressor
1pc
Rubber support leg
2 pcs
Air filter air filter
2 pcs
Wheels
2 pcs
Connection is fast removable 1 pc
Oil can for sale 1 pc
Instruction manual
1pc
Note
Technical errors and typos may be made in
the text and numerical designations of the in
structions.
Since the product is constantly being im
proved, P.I.T. reserves the right to make
changes to the specifications and product
specifications specified here without prior no
tice.
Assembly
►During any operations with the product
corresponding to the one specified in the
technical data. Check the oil level. The lev
el in the middle of the indicator is normal.
Top up if necessary;
►Tighten the oil filler cap;
Attention! Operation of the product with an
oil level above the maximum mark and with
the use of oil of an inappropriate type may
cause the product to fail. This malfunction is
not supported by the terms of the warranty
►Place the product on a flat, horizontal
surface. To ensure optimal air flow and
cooling of the compressor, do not install it
close to room walls and heaters at a dis
tance of less than 60 cm.
(assembly / disassembly, maintenance, oil
filling, connecting / disconnecting hoses),
make sure that the product is turned off
and disconnected from the mains.
Recommendations for use
The product must be on a strictly horizontal,
stable surface: this is a guarantee of its cor
5