Текст страницы
4 Installation
Caution:
Do not connect your ATI FirePro S400 synchronization module to AMD FirePro™
workstation cards that are not on the supported list; damage may result.
1. Turn off your computer, display(s), and other peripheral devices.
2. Unplug the computer's power cord and disconnect all cables from the back of
the computer.
Caution:
Wait approximately 20 seconds after unplugging the power cord before
disconnecting a peripheral or removing a component from the motherboard to
avoid possible damage to the motherboard.
3. Remove the cover to your computer's case.
Note: If necessary, consult your computer's manual for help in removing the
cover.
Caution:
Static electricity can seriously damage computer components. Discharge your
body's static electricity by touching the power supply or the metal surface of the
computer chassis before you touch any components inside your computer's case
to avoid damaging them.
4. Unscrew or unfasten and remove any existing synchronization modules from
your computer.
5. Locate an available PCI or PCIe® slot and, if necessary, remove the metal
baseplate cover. Make sure all internal cables are clear of the slot.
6. Align your ATI FirePro S400 synchronization module with the slot and press it
in firmly until the card is fully seated. You may need to hold open a locking tab
on the slot with your finger when you seat the card.
7. Screw in or fasten the synchronization module securely.
8. Connect a 15-pin SATA power cable from the power supply to the
synchronization module.
Note: Before installing a card that requires a supplementary power connection,
make sure your existing power supply has such a connection available.
Important: Do not connect a SATA data cable to the data portion of the SATA
connection on the synchronization board. The data pins are not used by this
product.
ATI FirePro™ S400 Syncronization Module
© 2009 Advanced Micro Devices, Inc.