Текст страницы
2 Getting Started
Figure 1–1 Typical Serial Number and Part Number Arrangement
1.3 Performing a Quick Installation
Experienced users and system administrators can follow these brief instructions for
installing this ATI FirePro S400 synchronization module.
Other users should refer to Chapter 2 Installation (p. 3).
Note: A synchronization module is usually installed at the same time as one or more
AMD FirePro workstation graphics cards.
1. Uninstall the drivers and software for any previously installed graphics card(s),
if they are being replaced.
Note: If you are using a motherboard containing an on-board graphics solution
and do not intend to use it as part of a multiple monitor display, disable it.
2. Shut down and disconnect your computer system.
3. Remove any installed graphics card(s), if they are being replaced.
4. Install your new AMD FirePro workstation graphics card(s) in the appropriate
PCIe slot(s), if appropriate.
Refer to your workstation card's user guide, as necessary.
5. Install your ATI FirePro S400 synchronization module in an available PCI or
PCIe slot, and connect it to your AMD FirePro workstation graphics card(s).
6. Reassemble and connect your computer system.
7. Install the latest drivers and configuration software for your AMD FirePro
workstation graphics card(s) from the AMD Web site. For more information,
refer to Drivers and Software (p. 5).
ATI FirePro™ S400 Syncronization Module
© 2009 Advanced Micro Devices, Inc.