Текст страницы
Please follow the instructions below to replace the Е11/Е11+АК filter:
1
Switch the device to Standby mode.
Disconnect the device from the power supply.
Remove the maintenance panel by pulling it towards you and then turn it over.
2-3
Turn the latches to remove the Epa filter-unit cover.
4-5
Insert the E11/E11+AK filter into the device.
Dispose of the filter with the expired resource.
6-10
Take the new Е11/E11+АК filter out of the packaging.
Insert the Е11/E11+АК filter into the casing and install it in the device.
Reinstall the Е11/E11+АК filter-unit cover.
Turn the latches to press the cover in place.
Reinstall the maintenance panel.
Connect the device to a power supply.
Switch the device to Operating mode.
Calibrate the СО2 sensor
For correct functioning of the sensor and correct display of CO2 readings, it is
necessary to calibrate the sensor at least once a month.
1
To do this, turn on the device in the Inflow air-intake mode
at maximum speed for 30 minutes.
2
Use the Tion Smart mobile app to calibrate the sensor or enable auto-calibration.
54