Текст страницы
2.3 Status Indicator
1. Px7 S2 Carton Contents
ENGLISH
The status LED indicator is located on the right
earpiece, the table below explains the illumination
states:
Px7 S2 over-ear wireless headphones
Storage case
USB-C to USB-C charging cable
USB-C to 3.5 mm audio cable
Document pack
Illumination
Operational state
2. Getting to Know Your Px7 S2
White
Battery charge > 30%
Amber
Battery charge between 30% and 10%
Red
Battery charge < 10%
We recommend installing the
Bowers & Wilkins Music app on your iOS or Android
device. This allows
you to configure your
headphones in detail and
provides helpful hints and
tips to make the most of
your new headphones.
Red flashing
Battery charge insufficient for headphone operation
bowerswilkins.com/downloadapp
2.1 Switching Headphones On and Off
Blue flashing
Pairing mode enabled
Diagram 1 illustrates power switch functionality.
Blue (2 sec solid)
Pairing successful
Blue flashing (calls)
Incoming call
Green flashing
Rapid charging
Switching On
The power switch is located on the right earpiece.
Slide the power switch up to the middle position. An
audible cue will be played and the LED indicator will
light up.
Green solid
Battery charge full, trickle charging
Switching Off
Slide the power switch to the bottom position. An
audible cue will be played and the headphones will
power down when the LED indictor is no longer lit.
Bluetooth Pairing
Slide the power switch to the upper position and
hold for 5 seconds to enter Bluetooth pairing mode.
Refer to section 6 for further information on pairing
your headphones to a Bluetooth source.
2.2 Headphone Controls
Diagram 2 illustrates the headphone controls. The
buttons on the right earpiece are used for media
playback and telephony.
Media Playback
Diagram 1
Power switch functionality
Function
Action
Play or pause
Press the Multi-function button once.
Play next
track
Press the Multi-function button
twice in quick succession. Note:
functionality dependent on source
device.
Play previous
track
Press the Multi-function button three
times in quick succession. Note:
functionality dependent on source
device.
Increase Volume
Press the Volume + button.
Lower Volume
Press the Volume - button.
Telephony
Function
Action
Answer an
incoming call
Press the Multi-function button once.
Power switch
End a call
Press the Multi-function button once.
Volume +
Decline an
incoming call
Hold the Multi-function button for 2
seconds.
Multi-function
Quick Action button
Volume -
Switch between
two calls
With two calls active, press the Multi-
function button twice.
Diagram 2
Merge two calls
Headphone controls
With two calls active, hold
the Multi-function button for
1 second.
3
Toggle mute
While on a call, press the Multi-
function button three times.