Текст страницы
Cleaning the Filter
EN
2. Push the dust cup release switch in the
direction indicated by the arrow, then
gently remove the dust cup from the
vacuum.
It is recommended to clean the filter once
every 4 to 6 months.
Fig. F-2
Fig. F-8
1. Remove the dust cup as shown in the
figure.
3. Remove the pre-filter first, then lift the
handle of the cyclone assembly and turn it
counterclockwise until it stops, then pull to
lift out the cyclone assembly.
Fig. F-3
2. Remove the filter from the vacuum by
pulling it down in the direction shown in
the figure.
Fig. F-9
4. Wipe the dust cup with a soft wet cloth.
Pay attention to wringing out the cloth
before using.
Fig. F-4
3. Clean the filter with clean water. Make
sure you rotate the filter 360° to thoroughly
and remove all dust caught in the filter.
Lightly tap the filter several times to
remove any excess dirt.
To avoid the risk of electric shock, do not
rinse the dust cup with water.
Fig. F-10
4. Allow the filter to air dry for 24 hours.
5. Rinse the cyclone assembly and pre-
filter until they are clean. After washing, air
dry for at least 24 hours .
Fig. F-11
Fig. F-5
Note：
Note:
• Only use clean water to wash the filter. Do
not use detergent.
• It is recommended to clean the dust cup
once every month.
• Do not attempt to clean the filter with a
brush or finger.
Installing the filter
• It is recommended to clean the pre-
filter at least once every 3 months and
the cyclone system at least once every 6
months.
1. Insert the filter into the vacuum and
gently press down, as illustrated.2.
Reinstall the dust cup.
Installing the Dust Cup, Pre-
Filter, and Cyclone Assembly
Fig. F-12
2. Reinstall the dust cup.
Fig. F-13
1. Insert the cyclone assembly vertically
into the dust cup, and make sure that the
handle of the cyclone assembly line up
with the slot on the left side of the dust
cup. Turn the handle clockwise until it
locks, then flip the handle down.
Cleaning the Illumination
Multi-surface Brush
2. Place the pre-filter with its front side
facing up into the cyclone assembly.
Fig. F-6
1. Turn the lock counterclockwise until it
stops, then remove the roller from the
roller brush.
Fig. F-14
3. Slightly tilt the dust cup so the slot aligns
with the clip on the vacuum. Then gently
push the dust cup until it clicks into place.
Fig. F-7
2. Use scissors to cut off the hairs and fibers
that get stuck on the brush roller. Wipe the
dust from the notch and transparent cover
with a dry cloth or paper towel. Thoroughly
dry before use.
Fig. F-15
18