Текст страницы
EN EN Routine Maintenance
Routine Maintenance
Main Brushes
Side Brush
Omnidirectional Wheel
Main Brushes
Remove and clean the side brush.
1. Press the brush guard clips inwards to remove the brush guard,
3. With the screen-printed arrows facing upwards, insert the main
brush holder into the slots downwards in an inclined way.
and then lift the brushes out of the robot.
Note:
2. Pull out the brushes as shown in the figure. Use the appropriate
4. Align the front end of the brush guard with the slot, insert it downwards
in an inclined way, and then press it into place.
cleaning tool to remove any hair tangled in the brushes. After
· Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel. Do not use excessive force.
· Rinse the omnidirectional wheel under the running water and put it back
after drying it completely.
cleaning, push the brushes firmly into the main brush holder until
they click into place.
1
Click
2
Note: Be careful while pulling out the main brushes to prevent injury.
17
18