Текст страницы
EN EN Routine Maintenance
Routine Maintenance
Robot Sensors
Charging Contacts and Signaling Area
Air Duct
Clean the charging contacts and the signaling area with a soft and dry cloth.
If the air duct is blocked, please clean it according to the following steps.
3. Reinstall the air duct cover.
Wipe robot sensors by using a soft and dry cloth, as shown in the below
figure:
1. Unscrew mounting screws on the air duct cover and remove the cover.
Laser Distance
Sensor (LDS)
Dock Sensors
Edge Sensor
Cliff Sensors
Auto-empty Vents
Clean the auto-empty vents of the robot and the base station with a soft
and dry cloth.
Battery
2. Check whether the air duct is blocked by foreign objects. If any, clean them.
The robot contains a high-performance lithium-ion battery pack. Make sure
that the battery remains well-charged for daily use to maintain optimal
battery performance. If the robot is not used for an extended period of
time, turn it off and put it away. To prevent damages from over-discharging,
charge the robot at least once every three months.
Note: A wet cloth can damage sensitive elements within the robot and the
base station. Please use a dry cloth for cleaning.
21
22