Текст страницы
EN
EN
How to Use
How to Use
Spot Cleaning
Use Mopping Function
3. Dampen the mop pad and wring out excess water. Install the mop pad as
shown in the figure.
5. When the robot returns to charge after cleaning, press the release clips
to remove the mop pad holder, and clean the mop pad to prevent mildew
or odors.
Note: It is recommended that floors are vacuumed at least three times
before the first mopping session to achieve a better cleaning effect.
When the robot is awaiting, press and hold the button
for 3 seconds to
enable the spot cleaning mode. In this mode, the robot cleans a square-
shaped area of 1.5 × 1.5 meters around it and returns to its starting point
once the spot cleaning is completed.
1. Press the release clip to remove the water tank.
Robot Restarting
1
2
3
If the robot stops responding or cannot be turned off, press and hold the
power button for 10 seconds to forcefully turn it off. Then, press and hold
the power button for 3 seconds to turn the robot on.
4. Reinstall the water tank and mop pad holder back as shown in the figure
until they click into place. Press the power button or use the app to start
cleaning.
2. Open the water inlet lid, fill the tank with water, and close the lid tightly.
Note:
· Wash the mop pad after each use, and regularly empty the water tank of
unused water.
· Remove the mop assembly when not mopping.
Click
Click
Note:
· Do not use detergent or disinfectant.
· Do not fill the water tank with hot water as this may cause the water tank
to warp.
Note:
· It is not recommended to use the mopping function on carpets.
· Use the app to adjust the mop pad moisture as required.
13
14